Catskill-craftsmen 64228 Manuale Utente

CRAFTSMEN, INC.Assembly Instructions Model 64220/64228Model 64220/64228A. These units are Ready-To-Assemble. Catskill uses positive fastening methods

STEP 9A. Stick magnet to magnet plate on a door.B. With all other doors open, close the door. The magnet should be positioned over the wooden block on

STEP 11A. Upright unit.B. Determine if you want the Knife Rack on the left or right Side Panel. The Handle/Towel Bar will go on the other. Then attach

STEP 13A. Tap 1” pins into the 4 sets of holes in the Back Panel. B. Just above the Bottom shelf on the inside of the Bottom Front Brace there are two

STEP 14 ONLY 64228A. Assemble top by placing the top and the drop leaf upside down on a smooth flat surface. Install hinges using 5/8 #8 screws. The l

STEP 15A. Slide the Drawer into the front of the cart. B. Tap in the 5/8 wooden plugs into the holes on the legs.C. Install Small Middle and Center Sh

For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. If you would like to purch

WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste

Parts List Model 64220Drawer Bottom (1)P/N DBOT-64220/28Small Middle Shelf (2)P/N SMS-64220/28Center Shelf (1)P/N CS-64220/28Bottom Shelf (1)P/N BS-64

Side Panel (2)P/N SP/HDL-64220/28 Divider Panel (2)P/N DP-64220/28Back Panel (1)P/N BP-64220P/N BP-64228Glide Support (2)P/N GLDSUP-64220/28Knife Rack

Hardware for 642201 3/4” Phillips Flat Head Bolt (8) 1 1/4” Phillips Flat Head #8 Screw (18) 1” Truss Head Machine Screw (12) 5/8” Pan Head Screw (8)

A. Tap/insert ONE 1 1/2” pin into each end of all the doors. DON’T OVERDRIVE PINS! Pins should stick up about 1/2” when seated.B. Attach the magnet pl

STEP 3A. Assemble Knife Rack by inserting four brass colored 1 1/4” #8 Screws through the countersunk (reamed out) holes in the Knife Rack into the pi

STEP 5ILLUSTRATION 5A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The countersunk holes (reamed out) in the st

STEP 6A. Lay Back Panel flat on a smooth surface with holes up.B. Attach Side Panels with 1 3/4” machine screws (bolts) and hex nuts. After inserting

STEP 8A. Install Doors by fitting the pins in the top of the door into the holes in the Top Front Brace. B. Place washers on the pins on the bottom of