Catskill-craftsmen 51576 Manuale Utente

Assembly InstructionsModel 51576Microwave Cart with Open/Enclosed StorageGENERAL:1. You have purchased model 51576. 2. Should you need assistance or n

STEP 9Attach towel bar to side panel with 1” #8 screws/washer from inside one panel.2 used in this step1” Phillips Flat Head #8 Screw2 used in this st

STEP 11A. Install doors by inserting pins in the door tops into the holes in the long edge of the middle front brace. B. Place one washer on each of t

STEP 13A. Insert and tap caster sockets with hammer until the teeth grab the wood. DON’T POUND SOCKET FLAT OR CASTER SHAFT WILL NOT ENTER.B. Insert ca

For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai

TOPTOPTOPCABINET PARTS 51576Glide Support Sticks (2) P/N: GLD SUP - 51576Handle Side Panel (1) P/N: SP/HDL - 51576Plain Side Panel (1) P/N: SP/PL - 51

1 3/4” Phillips Flat Head Bolt (10) 1 1/4” Phillips Flat Head #8 Screw (20) 7/8” Truss Head Machine Screw (6) 3/4” Long 3/16” DIA. Steel Pin (6) 1” Lo

STEP 11. Attach the Rack Top to the top ends of the Side Panels (universal: same left/right & top/bottom) using 1 1/4” #8 wood screws. MAKE SURE Y

STEP 2Note: The side panels are interchangeable at this point. Drawer glides will determine left or right sides. Choose at this point if you want the

STEP 3A. Lay Back Panel at on a smooth surface with holes up.B. Attach Side Panels with 1 3/4” bolts and hex nuts. After inserting bolts(s) thru the

STEP 5A. Turn the side/back assembly (from step 1) upside down (invert) on top of the inverted table top.B. Using the (X) marks from step 4 as a guide

5/8” #5STEP 6A. Attach the drawer back to the drawer sides with four 1 1/4” #8 screws. Make sure parts are aligned as in illustration 6A.B. Insert d

STEP 7Take the 2 front braces and tap/insert one 3/4” steel pin into each end of both braces until seated. About 3/8” will stick out when seated. Ok i